|
Post by slagjeep on Jul 22, 2014 14:48:41 GMT -10
In the past week I replaced my rear diff cover, diff fluids changed, new motor mounts, new Bilstein offroad shocks, oil pan gasket and rear main seal (thanks for the help, Mark). Replacing trans mount and drive belts before the ride. Yeah.... I'm stoked too! You have been hard at work sir.
|
|
|
Post by Jperk on Jul 22, 2014 15:27:57 GMT -10
Does anybody actually know who all is going? I know I've talked to a few that said they were.
|
|
|
Post by krisbodean85 on Jul 22, 2014 17:09:41 GMT -10
wish i could join yall guys but my jeep is not going to be ready by then i have to work on my 4wd shift linkage when i put the lift on the linkage hasnt worked right since then and have a hard time trying to figure out how to go about it. But maybe on the next run ill be ready. I fixed mine about a week ago. Easiest way to figure out where the problem is is to get somebody to shift it while you're under the jeep watching what's going on. On mine, the torque rod had come out of the bracket that mounts to the underside of the tub. What size lift did you do? I have a 4" skyjacker lift on it and it seems like it's hitting the tub on the shift lever I don't know that but that's just what it feels like it maybe the linkage I've been scratching my head on it for a while now
|
|
|
Post by slagjeep on Jul 22, 2014 17:14:46 GMT -10
This diagram helped me out a lot. Did the kit come with a drop bracket for the linkage?
|
|
|
Post by krisbodean85 on Jul 22, 2014 19:26:04 GMT -10
It did come with the bracket but it doesn't seem to work with it I put it in the bottom holes cause that's where the 4wd linkage needed to be and it was worse than it was when I didn't put the linkage now I have it on the second set of holes and it seems better but still pops out of 4wd if I don't hold it
|
|
|
Post by slagjeep on Jul 22, 2014 20:16:16 GMT -10
Did you adjust the shift linkage or just pop the bracket on there?
|
|
|
Post by krisbodean85 on Jul 23, 2014 2:41:12 GMT -10
I just pop it in there
|
|
|
Post by slagjeep on Jul 23, 2014 3:06:42 GMT -10
Do a search on Jeepforum about how to adjust the shift linkage on a TJ. I don't think it's too hard to do.
Here's an example
|
|
|
Post by krisbodean85 on Jul 23, 2014 3:37:27 GMT -10
i will thanks for the info if i can get it to work count me in thanks for your help
|
|
|
Post by slagjeep on Jul 23, 2014 6:13:00 GMT -10
i will thanks for the info if i can get it to work count me in thanks for your help Awesome! I'll put you on the list
|
|